Emetor logo

Blog RSS icon


Credits have expired

Posted on December 22, 2015

Many customers have decided to donate their remaining credits to charity now that all Emetor credits have expired - thank you very much. As a direct consequence, Emetor stays up and running even during 2016, completely free of charge! Read more about: Credits have expired...


Hint guide to outrunners in Emetor

Posted on September 1, 2015

This DIY guide by Simone Rambaldi is intended for people willing to design their own outrunner motors with rectangular magnets. However, most of the hints are also valid as general suggestions for the design of every type of electrical motor. Read more about: Hint guide to outrunners in Emetor...


Release 2015-06-01: Free simulations with non-linear material properties for everybody

Posted on June 1, 2015

With our updated license and subsription terms, we are glad to announce that everybody can now run simulations with non-linear material properties free of charge. Read more about: Release 2015-06-01: Free simulations with non-linear material properties for everybody...


How much does a simulation cost in Emetor?

Posted on May 29, 2015

Starting from 29 Maj 2015, all simulations with standard mesh density are completely free of charge, independent of whether the material properties are linear or non-linear. For higher mesh densities, the cost to run a simulation in Emetor depends on the runtime of your simulation and the required compute core type. Large simulations are more expensive than small simulations, but will always cost at least 1 credit. Read more about: How much does a simulation cost in Emetor?...


Updated VAT percentages for EU customers

Posted on April 1, 2015

The VAT percentages for private EU customers have now been updated in our shop according to new regulations. Read more about: Updated VAT percentages for EU customers...